Rear Crankshaft Oil Seal: Installation

1. Apply MP grease to the lip of a new oil seal.
   NOTE: Keep the lip free from foreign matter.
2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

   SST 09223-15030, 09950-70010 (09951 -07100) 

   NOTE:

   • Wipe any extra grease off the crankshaft.
   • Do not tap the oil seal at an angle.
   Fig 1: Installing Rear Engine Oil Seal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft.

   SST 09213-58013, 09330-00021 

   NOTE: Check the SST installation positions when installing them to prevent the SST fixing bolts from coming into contact with the timing chain cover sub-assembly.
   Fig 2: Installing Flywheel Sub-Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply adhesive to 2 or 3 threads of the bolt ends.

   Adhesive: 

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent 

   Fig 3: Applying Adhesive To Threads Of Bolt Ends

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

   Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 

   Fig 4: Locating Drive Plate Bolts Tighten Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Mark the top of the bolts with paint.
5. Retighten the 8 bolts an additional 90° in the same sequence.
6. Check that the paint marks are now at a 90° angle to the top.
7. Check that the crankshaft turns smoothly.

Fig 5: Identifying Crankshaft Bolt Tighten Angle

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft.

   SST 09213-58013, 09330-00021 

   NOTE: Check the SST installation positions when installing them to prevent the SST fixing bolts from coming into contact with the timing chain cover sub-assembly.
2. Clean the bolts and the bolt holes.
   Fig 6: Holding Crankshaft Using SST

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Apply a few drops of adhesive to 2 or 3 threads of the 8 bolts tip.

   Adhesive: 

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent 

4. Install the front drive plate spacer.

   HINT:

   Front spacer is reversible.

   Fig 7: Applying Adhesive To Threads Of Bolt Ends

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the drive plate and rear drive plate spacer onto the crankshaft.
   Fig 8: Installing Drive Plate And Rear Drive Plate Spacer

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

   Torque: 88 N*m (897 kgf*cm, 65 ft.*lbf) 

   Fig 9: Locating Drive Plate Bolt Tighten Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

See INSTALLATION for C59.

HINT:

See INSTALLATION for U341E.

HINT:

See INSTALLATION .