Drive Belt: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL V-RIBBED BELT
1. Install the belt.
Fig 1: Locating V-Ribbed Belt Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST V-RIBBED BELT
1. Turn bolt C to adjust the tension of the V-ribbed belt.
2. Tighten bolts A and B.
  Torque: Bolt A
  
  19 N*m (190 kgf*cm, 14 ft.*lbf)
  
  Bolt B
  
  43 N*m (438 kgf*cm, 32 ft.*lbf)
  
  NOTE: Confirm that bolt D is not loosened.
INSPECT V-RIBBED BELT (See ON-VEHICLE INSPECTION )

Fig 2: Locating V-Ribbed Belt Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ENGINE UNDER COVER RH
INSTALL NO. 2 CYLINDER HEAD COVER