CLUTCH RELEASE CYLINDER (for E351): Reassembly

WARNING: This page is about a different variant/trim than selected.

INSTALL CLUTCH RELEASE CYLINDER KIT
1. Coat a new piston with lithium soap base glycol grease as shown in the illustration.
2. Install the piston and a new spring to the cylinder body.
  NOTE: Do not damage the inside of the cylinder body.
  
  HINT:
  
  Install the smaller end of the spring to the piston.
  
  Fig 1: Locating Clutch Release Cylinder Kit
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install a new boot to the push rod.
4. Install the push rod to the cylinder body.
INSTALL RELEASE CYLINDER BLEEDER PLUG
1. Install the bleeder plug to the cylinder body.
  Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf)
2. Install the bleeder plug cap to the bleeder plug.