CLUTCH ACCUMULATOR (for E351): Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE RELEASE CYLINDER HEAT INSULATOR
1. Remove the 2 bolts and release cylinder heat insulator.
  
  Fig 1: Locating Cylinder Heat Insulator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH ACCUMULATOR BRACKET
1. Remove the 2 bolts and clutch accumulator bracket.
  
  Fig 2: Locating Clutch Accumulator Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT CLUTCH LINE
1. Using a union nut wrench (10 mm), remove the clutch line.
  HINT:
  
  Use a container to collect the fluid.
  
  Fig 3: Removing Clutch Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt and disconnect the clutch tube bracket.
  
  Fig 4: Locating Clutch Tube Bracket Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH ACCUMULATOR ASSEMBLY
1. Remove the 2 nuts and clutch accumulator assembly.
  
  Fig 5: Locating Clutch Accumulator Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002