Differential Oil Seal: Replacement

WARNING: This page is about a different variant/trim than selected.

REMOVE ENGINE UNDER COVER LH
REMOVE ENGINE UNDER COVER RH
DRAIN MANUAL TRANSAXLE OIL (See ON-VEHICLE INSPECTION )
REMOVE FRONT DRIVE SHAFT ASSEMBLY
See REMOVAL .
REMOVE TRANSMISSION CASE OIL SEAL
1. Using SST, remove the transmission case oil seal.
  SST 09308-00010
  
  Fig 1: Removing Transmission Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSAXLE CASE OIL SEAL
1. Using SST, remove the transaxle case oil seal.
  SST 09308-00010
  
  Fig 2: Removing Transaxle Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION CASE OIL SEAL
1. Coat the lip of a new oil seal with MP grease.
2. Using SST and a hammer, tap in the oil seal.
  SST 09710-26011 (09710-05061)
  
  Standard depth:
  
  9.6 to 10.2 mm (0.378 to 0.402 in.)
  
  NOTE: Do not damage the oil seal lip.
  
  Fig 3: Tapping In Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSAXLE CASE OIL SEAL
1. Coat the lip of a new oil seal with MP grease.
2. Using SST and a hammer, tap in the oil seal.
  SST 09636-20010
  
  Standard depth:
  
  1.6 to 2.2 mm (0.0630 to 0.0866 in.)
  
  NOTE: Do not damage the oil seal lip.
  
  Fig 4: Tapping In Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DRIVE SHAFT ASSEMBLY
See INSTALLATION .
ADD MANUAL TRANSAXLE OIL (See REPLACEMENT )
INSPECT MANUAL TRANSAXLE OIL (See ON-VEHICLE INSPECTION )
INSTALL ENGINE UNDER COVER LH
INSTALL ENGINE UNDER COVER RH