Front Crankshaft Oil Seal: Installation

INSTALL FRONT CRANKSHAFT OIL SEAL
1. Apply MP grease to the lip of a new front crankshaft oil seal.
2. Using SST and a hammer, tap in the front crankshaft oil seal until its surface is flush with the front oil seal retainer edge.
  SST 09223-22010
  NOTE:
  - Keep the lip free from foreign matter.
  - Do not tap on the oil seal at an angle.
    
    Fig 1: Tapping Front Crankshaft Oil Seal
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CRANKSHAFT PULLEY
1. While holding the crankshaft pulley in place with SST, tighten the bolt.
  SST 09213-54015 (91651-60855), 09330-00021
  
  Torque: 180 N*m (1835 kgf*cm, 133 ft.*lbf)
INSTALL V-RIBBED BELT (See REMOVAL )
INSPECT FOR OIL LEAK
INSTALL ENGINE UNDER COVER RH
INSTALL FRONT WHEEL RH
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)

Fig 2: Tightening Crankshaft Pulley Bolts With SST
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002