Data List / Active Test
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.- Warm up the engine.
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus:
- for Combination Meter: Body Electrical / Combination Meter / Data List.
- for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List.
- for Engine and ECT: Powertrain / Engine and ECT / Data List.
- for Main Body: Body Electrical / Main Body / Data List.
- Check values by referring to the table below.
Combination Meter
ITEM RANGE REFERENCE CHARTTester Display Measurement Item/Range Normal Condition Diagnostic Note Tail Relay SW Tail relay switch / OFF or ON OFF: The light control rheostat knob is not fully clockwise - ON: The light control rheostat knob is fully clockwise - ODO/TRIP Change SW ODO/TRIP switch / OFF or ON OFF: Switch is released - ON: Switch is pushed - P-Seatbelt Buckle SW Front passenger buckle switch / OFF or ON OFF: Seat belt is fastened - ON: Seat belt is unfastened - Vehicle Speed Meter Vehicle speed /
Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)Almost same as actual vehicle speed (Speedometer tester indication) - Engine Rpm Engine speed /
Min.: 0 rpm, Max.: 12750 rpmAlmost same as actual engine speed (Tachometer indication) If data received from the ECM exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range. Coolant Temperature Engine coolant temperature: 0°C (32°F)to 127.5°C (261.5°F) After warming up: 80 to 95°C (176 to 203°F) - If -40°C (-40°F) or less: Sensor circuit open
- If 140°C (284°F) or more: Sensor circuit shorted
+B Voltage Value Battery voltage /
Min.: 0 V, Max.: 25.5 V10 to 14 V - Integrated Value for Oil Maintenance(1) Oil maintenance warning value /
Min.: 0, Max.: 25500 (mile)The driving distance after performing oil maintenance resetting procedure is displayed If the value is 5000 (miles) or more, perform the oil maintenance resetting procedure after changing the oil. Fuel Input(2) Fuel input signal /
Min.: 0, Max.: 127.5Fuel gauge indicates (E): 5.0 (L) - Fuel gauge indicates (1/2): 25.0 (L) - Fuel gauge indicates (F): 42.6 (L) - Fuel Input(3) Fuel input signal /
Min.: 0, Max.: 127.5Fuel gauge indicates (E): 5.5 (L) - Fuel gauge indicates (1/2): 24.8 (L) - Fuel gauge indicates (F): 43.9 (L) - Ambient Temperature Outside temperature/Min.: -40°C (-40°F) to 50°C (122°F) Almost same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F). Communication ECM/Meter DTC 1 Communication error / not occurred or occurred Unrec: No Error has occurred - Rec: Error has occurred - ECM ODO (History 1) Distance when DTC is output /
Min.: 0, Max.: 999999- - Communication ECM/Meter DTC 2 Communication error / not occurred or occurred Unrec: No Error has occurred - Rec: Error has occurred - ECM ODO (History 2) Distance when DTC is output /
Min.: 0, Max.: 999999- - Communication ECM/Meter DTC 3 Communication error / not occurred or occurred Unrec: No Error has occurred - Rec: Error has occurred - ECM ODO (History 3) Distance when DTC is output /
Min.: 0, Max.: 999999- - Communication ABS/Meter DTC 1 Communication error / not occurred or occurred Unrec: No Error has occurred - Rec: Error has occurred - ABS/VSC ODO (History 1) Distance when DTC is output /
Min.: 0, Max.: 999999- - Communication ABS/Meter DTC 2 Communication error / not occurred or occurred Unrec: No Error has occurred - Rec: Error has occurred - ABS/VSC ODO (History 2) Distance when DTC is output /
Min.: 0, Max.: 999999- - Communication ABS/Meter DTC 3 Communication error / not occurred or occurred Unrec: No Error has occurred - Rec: Error has occurred - ABS/VSC ODO (History 3) Distance when DTC is output /
Min.: 0, Max.: 999999- - Driver Side Seatbelt Warning Buzzer The condition of the driver side seat belt warning buzzer/ OFF or ON ON: The driver side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt is unfastened The current setting of the driver side seat belt warning buzzer is displayed. OFF: The driver side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt is unfastened P-Seatbelt Warning Buzzer The condition of the front passenger side seat belt warning buzzer / OFF or ON ON: The front passenger side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt is unfastened The current setting of the front passenger side seat belt warning buzzer is displayed. OFF: The front passenger side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt is unfastened Number of Trouble Code The number of the DTC which is currently output 0 - (1) for U.S.A. (2) for 2WD (3) for 4WD ABS/VSC/TRAC
ITEM RANGE REFERENCE CHARTTester Display Measurement Item/Range Normal Condition Diagnostic Note FR Wheel Speed FR wheel speed sensor reading /
min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph)Actual wheel speed Similar speed as indicated on speedometer FL Wheel Speed FL wheel speed sensor reading /
min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph)Actual wheel speed Similar speed as indicated on speedometer RR Wheel Speed RR wheel speed sensor reading /
min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph)Actual wheel speed Similar speed as indicated on speedometer RL Wheel Speed RL wheel speed sensor reading /
min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph)Actual wheel speed Similar speed as indicated on speedometer Vehicle Speed Maximum wheel speed sensor reading /
min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph)Actual vehicle speed Speed indicated on speedometer Engine and ECT (for 2AZ-FE)
ITEM RANGE REFERENCE CHARTTester Display Measurement Item/Range Normal Condition Diagnostic Note Engine Speed Engine speed:
Min.: 0 rpm, Max.: 16383.75 rpm650 to 750 rpm: Idling - Coolant Temp Engine coolant temperature:
Min.: -40°C (-40°F), Max.: 140°C (284°F)80 to 100°C (176 to 212°F): After warming up - If value -40°C (-40°F): sensor circuit open
- If value 140°C (284°F): sensor circuit shorted
Engine and ECT (for 2ZR-FE)
ITEM RANGE REFERENCE CHARTTester Display Measurement Item/Range Normal Condition Diagnostic Note Engine Speed Engine speed:
Min.: 0 rpm, Max.: 16383.75 rpm650 to 750 rpm: Idling (Automatic transaxle) 600 to 700 rpm: Idling (Manual transaxle) - Coolant Temp Engine coolant temperature:
Min.: -40°C (-40°F), Max.: 140°C (284°F)80 to 100°C (176 to 212°F): After warming up - If value -40°C (-40°F): sensor circuit open
- If value 140°C (284°F): sensor circuit shorted
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the operation by referring to the table below.
Combination Meter
CONTROL RANGE REFERENCETester Display Test Part Control Range Diagnostic Note Speed Meter Operation Speedometer 0, 40, 80, 120 mph(1) - 0, 40, 80, 120, 160, 200, 240 km/h(2) - Tacho Meter Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm) - Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2, FULL Confirm that the vehicle is stopped while the engine is idling Water Temperature Meter Operation Engine coolant temperature receiver gauge Low, Normal, High Confirm that the vehicle is stopped while the engine is idling A/T Indicator Operation 1 A/T shift indicator light A/T shift indicator light L, 2, 3, 4, D, N, R, P is OFF or ON Confirm that the vehicle is stopped while the engine is idling Meter Display 1 Multi-information display All the dots in the multi-information display OFF or ON Confirm that the vehicle is stopped while the engine is idling Meter Display 2 A/T shift indicator display The segments in the A/T shift indicator display OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Airbag SRS warning light SRS warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Front Passenger Side Seat Belt Front passenger side seat belt warning light Front passenger side seat belt warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Driver Side Seat Belt Driver side seat belt warning light Driver side seat belt warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp ABS ABS warning light ABS warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Charge Charge warning light Charge warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Slip Slip indicator light Slip indicator light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Beam Hi-beam indicator light Hi-beam indicator light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Head(1) Head indicator light Head indicator light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Tail(2) Tail indicator light Tail indicator light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Fr FOG(3) Front fog indicator light Front fog indicator light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Driver Side Door Open Open door warning light Open door warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Front Passenger Side Door Open Open door warning light Open door warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Rear Door RH Open Open door warning light Open door warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Rear Door LH Open Open door warning light Open door warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Back Door Open Open door warning light Open door warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Washer Washer fluid level warning light Washer fluid level warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Fuel Low fuel warning light Fuel level warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Tire Pressure Warning System(4) Tire pressure warning light Tire pressure warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Oil Pressure Oil pressure warning light Oil pressure warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling A/T Oil Temperature Operation A/T fluid temperature indicator light A/T fluid temperature warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Cruise Cruise indicator light Cruise indicator light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Lamp Brake Brake warning light Brake warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. EPS EPS warning light EPS warning light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. Oil Maintenance(1) Oil maintenance reminder light Oil maintenance reminder light is OFF or ON Confirm that the vehicle is stopped while the engine is idling Indicat. VSC OFF(5) VSC OFF indicator light VSC OFF indicator light is OFF or ON Confirm that the vehicle is stopped while the engine is idling (1) for U.S.A. (2) except for U.S.A. (3) w/ Front Fog Light (4) w/ Tire Pressure Warning System (5) w/ VSC