Inspection Procedure

1. Disconnect the E55 connector.
2. Measure the resistance according to the value (s) in the table below.

   Standard Resistance 

   RESISTANCE REFERENCE
   
   

   Tester Connection	Condition	Specified Condition
   E55-30 (ET) - Body ground	Always	Below 1 Ω

Fig 1: Identifying E55 Connector Terminal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Measure the voltage according to the value (s) in the table below.

Standard Voltage 

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE COMBINATION METER (See  COMBINATION METER  )