LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Land Cruiser >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Intake / Exhaust Assembly >> Exhaust Manifold >> Removal

Exhaust Manifold: Removal

  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH  (See REMOVAL )
  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH  (See REMOVAL )
  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE NO. 2 ENGINE UNDER COVER  (See REMOVAL )
  5. REMOVE FRONT FENDER APRON SEAL FRONT RH 
    1. Using a clip remover, remove the 3 clips and fender apron seal.
      Fig 1: Identifying Front Fender Apron Seal Clip (RH)
      G05638049Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT FENDER APRON SEAL REAR RH 
    1. Using a clip remover, remove the 4 clips and fender apron seal.
      Fig 2: Identifying Rear Fender Apron Seal Clip (RH)
      G05638050Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE FRONT FENDER APRON SEAL LH 
    1. Using a clip remover, remove the 3 clips and fender apron seal.
      Fig 3: Identifying Front Fender Apron Seal (LH)
      G05638051Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE FRONT FENDER APRON SEAL REAR LH 
    1. Using a clip remover, remove the 4 clips and fender apron seal.
      Fig 4: Identifying Front Fender Apron Seal Rear Clips (LH)
      G05638052Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE  (See REMOVAL )
  10. REMOVE TAILPIPE ASSEMBLY  (See REMOVAL  )
  11. REMOVE CENTER EXHAUST PIPE ASSEMBLY  (See REMOVAL  )
  12. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY  (See REMOVAL  )
  13. REMOVE FRONT EXHAUST PIPE ASSEMBLY  (See REMOVAL  )
  14. REMOVE PROPELLER SHAFT HEAT INSULATOR 
    1. Remove the 2 bolts and heat insulator.
      Fig 5: Locating Heat Insulator With Bolts
      G05638053Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE NO. 2 MANIFOLD STAY 
    1. Remove the 2 bolts and manifold stay.
      Fig 6: Locating Manifold Stay Bolts
      G05638054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR 
    1. Remove the 3 bolts and heat insulator.
      Fig 7: Locating No. 2 Exhaust Manifold Heat Insulator Bolts
      G05152767Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH 
    1. Remove the 10 nuts, exhaust manifold and 2 gaskets.
      Fig 8: Locating Exhaust Manifold Nuts
      G05152768Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  18. REMOVE NO. 1 MANIFOLD STAY 
    1. Remove the 2 bolts and manifold stay.
      Fig 9: Locating No. 1 Manifold Stay Bolts
      G05638057Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR 
    1. Remove the 3 bolts and heat insulator.
      Fig 10: Locating No. 1 Exhaust Manifold Heat Insulator Bolts
      G05152769Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  20. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH 
    1. Remove the 2 nuts and insulator from the exhaust manifold.
      Fig 11: Locating Exhaust Manifold Insulator Nut
      G05638059Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 10 nuts, exhaust manifold and 2 gaskets.
      Fig 12: Locating Exhaust Manifold Nuts
      G05152770Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals