Parking Brake Assembly: Disassembly

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

REMOVE REAR WHEEL LH
DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
1. Remove the 2 bolts and disconnect the rear disc brake cylinder.
  NOTE:
  - Do not disconnect the flexible hose from the disc brake cylinder.
  - Do not twist or bend the flexible hose.
2. Hang the disc brake cylinder with a piece of wire.
  
  Fig 1: Locating Rear Disc Brake Cylinder Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR DISC
1. Put matchmarks on the rear disc and axle hub if planning to reuse the disc.
  
  Fig 2: Identifying Matchmarks On Rear Disc And Axle Hub
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the shoe adjuster until the disc turns freely, and then remove the disc.
  
  Fig 3: Turning Shoe Adjuster
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PARKING BRAKE SHOE RETURN SPRING
1. Using SST, remove the return spring.
  SST 09703-30011
  
  Fig 4: Removing Return Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
1. Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.
  SST 09718-00011
  
  Fig 5: Removing Shoe Hold Down Spring Cup, Compression Spring And Shoe Hold Down Spring Pin
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the tension spring from the No. 1 parking brake shoe.
  
  Fig 6: Identifying No. 1 Parking Brake Shoe Tension Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the No. 1 parking brake shoe and shoe adjuster screw set.
  
  Fig 7: Identifying No. 1 Parking Brake Shoe And Shoe Adjuster Screw Set
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
1. Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.
  SST 09718-00011
2. Remove the No. 2 parking brake shoe.
REMOVE PARKING BRAKE SHOE LEVER LH
1. Disconnect the No. 3 parking brake cable from the parking brake shoe lever.
  
  Fig 8: Removing Shoe Hold Down Spring Cup, Compression Spring And Shoe Hold Down Spring Pin
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the parking brake shoe lever.
  
  Fig 9: Removing Parking Brake Shoe Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
1. Remove the bolt and disconnect the No. 3 parking brake cable.
  
  Fig 10: Locating No. 3 Parking Brake Cable Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PARKING BRAKE ANCHOR BLOCK
1. Remove the 2 nuts and anchor block.
  
  Fig 11: Locating Parking Brake Anchor Block Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002