Rear Brake Pad, Brake Caliper & Brake Rotor: Disassembly

REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
REMOVE REAR DISC BRAKE BLEEDER PLUG
REMOVE CYLINDER BOOT
1. Using a screwdriver, remove the cylinder boot from the cylinder.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Removing Cylinder Boot From Cylinder
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR DISC BRAKE PISTON
1. Place a piece of cloth or a similar object between the piston and cylinder.
2. Use compressed air to remove the piston from the cylinder.
  CAUTION: Do not place your fingers in front of the piston when using compressed air.
  
  Fig 2: Removing Piston From Cylinder
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PISTON SEAL
1. Using a screwdriver, remove the piston seal from the cylinder.
  HINT:
  
  Tape the screwdriver tip before use.
  
  NOTE: Do not damage the inner cylinder and cylinder groove.
  
  Fig 3: Removing Piston Seal From Cylinder
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002