How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the meter/gauge system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard Voltage: 11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

3. CHECK FOR DTC* 
   1. Check for DTCs and note any codes that are output (See DTC CHECK / CLEAR  ).
   2. Clear the DTCs (See DTC CHECK / CLEAR  ).
   3. Recheck for DTCs. Based on the DTCs output above, try to force output of the same CAN communication system DTC or meter/gauge system DTC by simulating the symptoms indicated by the DTC.

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC is not output	A
      CAN communication system DTC is output	B
      Meter/gauge system DTC is output	C

   B: Go to CAN COMMUNICATION SYSTEM  (See CAN COMMUNICATION SYSTEM )

   C: Go to DIAGNOSTIC TROUBLE CODE CHART  (See DIAGNOSTIC TROUBLE CODE CHART  )

   A: Go to next step. 

4. PROBLEM SYMPTOMS TABLE 
   1. Refer to PROBLEM SYMPTOMS TABLE  ).

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      Fault is not listed in problem symptoms table	A
      Fault is listed in problem symptoms table	B

   B: Go to step  7

   A: Go to next step. 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Terminals of ECU (See TERMINALS OF ECU  )
   2. Data List / Active Test (See DATA LIST / ACTIVE TEST  )
   3. Operation Check (See OPERATION CHECK  )
6. REPAIR OR REPLACE 
7. CONFIRMATION TEST 

   NEXT: END