Stop Light Switch: Installation

INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
1. Install a new stop light switch mounting adjuster to the pedal support.
  
  Fig 1: Inspecting Stop Light Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STOP LIGHT SWITCH
1. Install the stop light switch to the adjuster until it slightly touches the brake pedal.
  NOTE: Do not depress the brake pedal.
  
  Fig 2: Identifying Brake Pedal, Adjuster And Stop Light Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the stop light switch quarter in clockwise to install it.
  NOTE: Do not depress the brake pedal.
  
  Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf)
3. Check the stop light switch clearance.
  Stop light switch clearance:
  
  1.5 to 2.5 mm (0.0590 to 0.0984 in.)
4. Connect the wire harness clamp to the pedal support.
5. Connect the connector to the stop light switch.
  
  Fig 3: Turning Stop Light Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002