Rear Shock Absorber: Disposal

DISPOSE OF REAR SHOCK ABSORBER (for 2WD)
1. Fully extend the shock absorber piston rod.
2. Using a drill, make a hole in area B shown in the illustration to discharge the gas inside.
  Length (A):
  
  25 mm (0.98 in.)
  
  Length (B):
  
  25 mm (0.98 in.)
  
  Fig 1: Identifying Rear Shock Absorber Hole Area (2WD)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CAUTION:
- Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.
- The gas is colorless, odorless and non-poisonous.
DISPOSE OF REAR SHOCK ABSORBER (for 4WD)
1. Fully extend the shock absorber piston rod.
2. Using a drill, make a hole in area B shown in the illustration to discharge the gas inside.
  Length (A):
  
  25 mm (0.98 in.)
  
  Length (B):
  
  25 mm (0.98 in.)
  CAUTION:
  - Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.
  - The gas is colorless, odorless and non-poisonous.
  Fig 2: Identifying Rear Shock Absorber Hole Area (4WD)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002