FRONT STABILIZER BAR (for 1AR-FE): Inspection

INSPECT FRONT STABILIZER LINK ASSEMBLY
1. Inspect the turning torque of the ball joint.
  1. Secure the front stabilizer link assembly in a vise using aluminum plates.
  2. Install the nut to the front stabilizer link assembly stud.
  3. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.
    Turning torque:
    
    0.05 to 1.96 N*m (0.5 to 20 kgf*cm, 0.4 to 17 in.*lbf)
  Fig 1: Inspecting Front Stabilizer Link Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  If the turning torque is not within the specified range, replace the front stabilizer link assembly with a new one.
2. Inspect the dust cover.
  1. Check that the dust cover is not cracked and that there is no grease on it.