LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Emission Control System (1AR-FE)) >> Purge Valve >> Installation

Purge Valve: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL NO. 1 VACUUM SWITCHING VALVE 
    1. Install the No. 1 vacuum switching valve to the air cleaner hose.
    2. Connect the 2 fuel vapor feed hoses to the No. 1 vacuum switching valve.

      HINT:

      The direction of the hose clamp is indicated in the illustration.

    3. Connect the wire harness clamp.
    4. Connect the No. 1 vacuum switching valve connector.
    Fig 1: Locating Fuel Vapor Feed Hoses And No. 1 Vacuum Switching Valve Connector
    G06115096Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See INSTALLATION )
  4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
  7. INSTALL EJECTOR TUBE  (See INSTALLATION )
scientia non olet · About LEMON Manuals