Section 9 (Emission Control System (1AR-FE)): Canister: Remove

WARNING: This page is about a different variant/trim than selected.

REMOVE TAIL EXHAUST PIPE ASSEMBLY (See INSTALLATION )
REMOVE CENTER EXHAUST PIPE ASSEMBLY (See INSTALLATION )
REMOVE NO. 3 FRONT FLOOR HEAT INSULATOR
1. Remove the 4 bolts and No. 3 front floor heat insulator.
Fig 1: Locating No. 3 Front Floor Heat Insulator Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CHARCOAL CANISTER ASSEMBLY
1. Disconnect the hose and connector.
  
  Fig 2: Locating Hose And Charcoal Canister Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the tube.
  
  Fig 3: Locating Charcoal Canister Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the charcoal canister fuel hose from the charcoal canister assembly.
  1. Pinch the retainer and pull out the quick connector with the quick connector pushed to the pipe side to disconnect the charcoal canister fuel hose from the charcoal canister assembly.
    NOTE:
    Remove dirt or foreign objects on the quick connector before this work.
    
    Do not allow any scratches or foreign objects on the parts when disconnecting as the fuel hose connector has the O-ring that seals the pipe.
    
    Perform this work by hand. Do not use any tools.
    
    Do not forcibly bend, twist or turn the nylon tube.
    
    Protect the connected part by covering it with a vinyl bag after disconnecting the charcoal canister fuel hose.
    
    If the quick connector and pipe are stuck, push and pull them to release.
    Fig 4: Pinching Retainer And Pushed To Pipe Side To Disconnect Charcoal Canister Fuel Hose From Charcoal Canister Assembly
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 3 nuts and charcoal canister assembly.
Fig 5: Locating Charcoal Canister Assembly Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002