Section 9 (Emission Control System (1AR-FE)): Canister: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL CHARCOAL CANISTER ASSEMBLY
1. Connect the charcoal canister assembly with the 3 nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  Fig 1: Locating Charcoal Canister Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Align the quick connector with the pipe, then push in the quick connector until the retainer makes a "click" sound to connect the charcoal canister fuel hose to the charcoal canister assembly.
  NOTE:
  - Check that there are no scratches or foreign objects around the connected part of the quick connector and pipe before this work.
  - After connecting the charcoal canister fuel hose, confirm that it is securely connected by pulling the quick connector.
  Fig 2: Aligning Quick Connector With Pipe
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the hose.
  
  Fig 3: Locating Charcoal Canister Fuel Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the hose and connector.
Fig 4: Locating Hose And Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 3 FRONT FLOOR HEAT INSULATOR
1. Install the No. 3 front floor heat insulator with the 4 bolts.
  Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf)
INSTALL CENTER EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL TAIL EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSPECT FOR EXHAUST GAS LEAK

Fig 5: Locating No. 3 Front Floor Heat Insulator Bolts