On-Vehicle Cleaning
WARNING: This page is about a different variant/trim than selected.
- INSPECT RADIATOR ASSEMBLY
- Check that the radiator and condenser are not blocked with leaves, dirt, or insects. Clean the hose connections.
If the fins are blocked, wash them with water or a steam cleaner.
NOTE:- If the distance between the steam cleaner and core is too close, the fins may be damaged.
- Keep the following injection distance.
Standard injection distance
INJECTION PRESSURE CHARTInjection Pressure Specified Condition 2942 to 4903 kPa (30 to 50 kgf/cm2 , 427 to 711 psi) 300 mm (11.81 in.) 4903 to 7845 kPa (50 to 80 kgf/cm2 , 711 to 1138 psi) 500 mm (19.69 in.) - If the fins are bent, straighten them with a screwdriver or pliers.
- Never apply water directly onto the electronic components.
- Dry the fins with compressed air.
- Check that the radiator and condenser are not blocked with leaves, dirt, or insects. Clean the hose connections.