Oil Pressure Switch: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
1. Apply adhesive to 2 or 3 threads of the oil pressure switch.
  Adhesive:
  
  TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.
  
  NOTE: Do not let adhesive adhere to the oil hole.
  
  Fig 1: Applying Adhesive To Threads Of Oil Pressure Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a 24 mm deep socket wrench, install the oil pressure switch.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  NOTE: Do not start the engine within 1 hour of installation.
3. Connect the oil pressure switch connector.
INSPECT FOR OIL LEAK (See OIL PRESSURE SWITCH )

Fig 2: Installing Oil Pressure Switch

G06115557

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002