Engine Oil Cooler: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE OIL COOLER ASSEMBLY
1. Clean the oil cooler contact surface on the cooler mounting.
2. Apply a light coat of engine oil to 3 new gaskets.
3. Install the 3 new gaskets to the engine oil cooler assembly.
4. Temporarily install the engine oil cooler assembly with the union bolt, nut and a new seal washer.
5. Tighten the bolt and nut in several steps, in the sequence shown in the illustration.
  Torque: Union Bolt
  
  60 N*m (612 kgf*cm, 44 ft.*lbf)
  
  Nut
  
  10 N*m (102 kgf*cm, 7 ft.*lbf)
INSTALL EXHAUST MANIFOLD ASSEMBLY
HINT:

See INSTALLATION

Fig 1: Identifying Union Bolt And Nut Tightening Sequence
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADD ENGINE OIL (See OIL PRESSURE SWITCH )
ADD ENGINE COOLANT (See COOLANT )
CHECK ENGINE OIL LEVEL (See LUBRICATION SYSTEM )
INSPECT FOR OIL LEAK