Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK LOCK FUNCTION OF CLUTCH PULLEY
1. Check the lock function with the pulley installed in the vehicle.
  1. Visually check that the rotor in the generator operates with the engine started.
2. Check the lock function with the pulley removed from the vehicle.
  1. Remove the generator pulley cap. Using SST, hold the generator rotor.
  2. Turn the clutch pulley clockwise and check that the outer ring locks.
OK:

The outer ring locks.

SST 09820-63021

NG: REPLACE CLUTCH PULLEY (See GENERATOR )

Fig 1: Checking Lock Function Of Clutch Pulley
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to next step
CHECK LOCK OF CLUTCH PULLEY
1. Start the engine and visually check for looseness of the clutch pulley.
OK:

The clutch pulley is not loose.

NG: TIGHTEN CLUTCH PULLEY TO THE SPECIFIED TORQUE (See GENERATOR )

OK: REPLACE GENERATOR ASSEMBLY (See GENERATOR )