LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical (1AR-FE)) >> Rear Crankshaft Oil Seal >> Installation

Rear Crankshaft Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL REAR ENGINE OIL SEAL 
    1. Apply MP grease to the lip of a new oil seal.
      NOTE:
      • Do not allow foreign matter to contact the lip of the oil seal.
      • Do not allow MP grease to contact the dust seal.
    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      SST 09223-15030, 09950-70010 (09951 -07150) 

      NOTE:
      • Keep the lip of the oil seal free from foreign matter.
      • Do not tap in the oil seal at an angle.
      Fig 1: Tapping Oil Seal Using SST
      G05997872Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY 
    1. Using SST, hold the crankshaft.

      SST 09213-54015, 09330-00021, 91551 -80650 

    2. Clean the bolts and their installation holes.
      Fig 2: Holding Crankshaft Pulley Using SST
      G06030119Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the front drive plate spacer.

      HINT:

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

      Fig 3: Identifying Front Drive Plate Spacer
      G05997875Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the drive plate and rear drive plate spacer onto the crankshaft.
      Fig 4: Installing Drive Plate And Rear Drive Plate Spacer Onto Crankshaft
      G06030125Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Apply a few drops of adhesive to 2 or 3 threads of the 8 bolts.

      Adhesive: 

      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent 

      Fig 5: Applying Drops Of Adhesive To Threads Of Bolts
      G05997874Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.

      Torque: 98 N*m (999 kgf*cm, 72 ft.*lbf) 

      NOTE: Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.
  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY 
    1. Install the automatic transaxle (See DISASSEMBLY ).
    Fig 6: Identifying Drive Plate Bolts Tightening Sequence
    G05997877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL ENGINE AND TRANSAXLE 
    1. Install the engine and transaxle (See INSTALLATION ).
scientia non olet · About LEMON Manuals