Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
All:
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever these DTCs are not stored | None |
| Engine coolant temperature | -10°C (14°F) or higher |
| Intake air temperature | -10°C (14°F) or higher |
| Control valve half-open operation | Not operated |
| Ignition switch | ON |
| Control valve | Not operated by scan tool |
| Battery voltage during close operation | 8 V or higher |
| When either condition below is met | Condition A or B |
| A. When both conditions below are met | - |
| Engine coolant temperature at engine start | 5°C (41°F) or higher |
| Intake air temperature at engine start | 5°C (41°F) or higher |
| B. When both conditions below are met | - |
| Engine coolant temperature | 70°C (158°F) or higher |
| Vehicle speed | Less than 46 mph (75 km/h) |
P2004:
TYPICAL ENABLING CONDITIONS CHART
| Command to control valve | Closed |
P2006:
TYPICAL ENABLING CONDITIONS CHART
| Command to control valve | Open |