Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
TYPICAL MALFUNCTION THRESHOLDS CHART
| Either of the following conditions is met: | Condition 1 or 2 |
| 1. Frequency that both of the following conditions (a) and (b) are met | 5 times or more |
| (a) Either of the following conditions is met: | Condition A or B |
| A. Engine speed - target engine speed | Less than -100 rpm, or 150 rpm or more (A/C off and NSW off) |
| B. Engine speed - target engine speed | Less than -100 rpm, or 200 rpm or more (A/C on or NSW on) |
| (b) Vehicle condition | Stop after vehicle was driven by 6.25 mph (10 km/h) or more |
| 2. Frequency that both of the following conditions (a) and (b) are met | Once |
| Either of the following conditions is met: | Condition A or B |
| A, Engine speed - target engine speed | Less than -100 rpm, or 150 rpm or more (A/C off and NSW off) |
| B, Engine speed - target engine speed | Less than -100 rpm, or 200 rpm or more (A/C on or NSW on) |
| (b) Idle air control flow rate learning valve | 0.9 L/sec. or less, or 6 L/sec. or more |