Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever these DTCs are not present | None |
| Time after ignition switch off to ON | 3 seconds or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Either of the following conditions is met | Condition 1 or 2 |
| 1. Both of the following conditions are met | Condition (a) or (b) |
| (a) Engine coolant temperature | 20°C (68°F) or more |
| (b) Engine coolant temperature sensor fail (P0115, P0117, P0118, P0125) | Not detected |
| (c) Time after park/neutral position switch ON to OFF | 10 seconds or more |
| 2. Both of the following conditions are met | Conditions (a) and (b) |
| (a) Engine coolant temperature | Less than 20°C (68°F) |
| (b) Engine coolant temperature sensor fail (P0115, P0117, P0118, P0125) | Detected |
| (c) Time after park/neutral position switch ON to OFF | 30 seconds or more |
| Engine speed with throttle position sensor opening angle is below 13° | 2300 rpm or more |
| Engine speed with throttle position sensor opening angle is below 21° | 2700 rpm or more |
| Engine speed with throttle position sensor opening angle is below 30° | 2850 rpm or more |
| Engine speed with throttle position sensor opening angle is 30° or more | 3250 rpm or more |
| Throttle position sensor fail (P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135) | Not detected |