Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
P0365: Exhaust Camshaft Position Sensor Verify Pulse Input
TYPICAL ENABLING CONDITIONS CHART
| Monitor runs whenever following DTCs not stored | None |
| Engine speed | 600 rpm or more |
| Exhaust camshaft position sensor range check fail (P0367, P0368) | Not detected |
| Ignition switch | ON |
| Starter | OFF |
| Battery voltage | 8 V or higher |
| Exhaust camshaft position sensor voltage | 0.3 to 4.7 V |
P0367, P0368: Exhaust Camshaft Position Sensor Range Check
TYPICAL ENABLING CONDITIONS CHART
| Monitor runs whenever following DTCs not stored | None |
| Starter | OFF |
| Ignition switch | ON |
| Time after ignition switch turned from off to ON | 2 seconds or more |
| Exhaust camshaft position sensor verify pulse input fail (P0365) | Not detected |
| Battery voltage | 8 V or higher |