Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
P0335: Crankshaft Position Sensor Range Check/Rationality
TYPICAL ENABLING CONDITIONS CHART
| Monitor runs whenever following DTCs not stored | None |
| Time after starter OFF to ON | 3 seconds or more |
| Number of camshaft position sensor signal pulses | 6 times |
| Battery voltage | 7 V or higher |
| Minimum battery voltage while starter ON | Below 11 V |
| Camshaft position sensor circuit (P0340, P0342, P0343) | Not detected |
P0355: Crankshaft Position Sensor Verify Pulse Input
TYPICAL ENABLING CONDITIONS CHART
| Monitor runs whenever following DTCs not stored | None |
| Starter | OFF |
| Engine speed | 600 rpm or less |
| Time after starter from ON to OFF | 3 seconds or more |
P0355: Crankshaft Position Sensor Verify Pulse Input
TYPICAL ENABLING CONDITIONS CHART
| Monitor runs whenever following DTCs not stored | None |
| Starter | ON |
| Minimum battery voltage while starter ON | Below 11 V |