Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever these DTCs are not stored | None |
| Both of following conditions met | Conditions 1 and 2 |
| 1. All of following conditions met | Conditions (a), (b), (c) and (d) |
| (a) Time after ignition switch ON and engine not running | Less than 20 seconds |
| (b) Soak Time | 7 hours or more |
| (c) Battery voltage | 10.5 V or higher |
| (d) Time after engine start | 15 seconds or more |
| 2. Either of the following conditions is met | Conditions (a) and (b) |
| (a) Minimum intake air temperature after engine start | -10°C (14°F) or higher |
| (b) Average engine coolant temperature before engine start | -10°C (14°F) or higher |
| Soak timer circuit fail (P2610) | Not detected |