Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
All
TYPICAL ENABLING CONDITIONS CHART
| Monitor runs whenever following DTCs not stored | None |
Engine Coolant Temperature Sensor Cold Start Monitor
TYPICAL ENABLING CONDITIONS CHART
| Battery voltage | 10.5 V or higher |
| Time after engine start | 1 second or more |
| Engine coolant temperature at engine start | Below 60°C (140°F) |
| Soak time | 0 seconds or more |
| Accumulated mass air flow | 931 g or more |
| Fuel cut | OFF |
| Intake air temperature sensor circuit fail (P0112, P0113) | Not detected |
| Difference between engine coolant temperature at engine start and intake air temperature | Below 40°C (72°F) |
Engine Coolant Temperature Sensor Soak Monitor
TYPICAL ENABLING CONDITIONS CHART
| Battery voltage | 10.5 V or higher |
| Engine | Running |
| Soak time | 5 hours or more |
| Either condition (a) or (b) met | - |
| (a) Engine coolant temperature | 60°C (140°F) or higher |
| (b) Accumulated mass air flow | 1993 g or more |
| Intake air temperature sensor circuit fail (P0112, P0113) | Not detected |