LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System (1AR-FE) - DTC P0010 - P0120/P0121/P0122/P0123/P0220/P0222/P0223/P2135) >> DTC P0014 Camshaft Position "B" - Timing Over-Advanced or System Performance (Bank 1); DTC P0015 Camshaft Position "B" - Timing Over-Retarded (Bank 1) >> Confirmation Driving Pattern

Confirmation Driving Pattern

WARNING: This page is about a different variant/trim than selected.
Fig 1: Vehicle Speed Driving Pattern
G05996792Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Connect the Techstream to the DLC3.
  2. Turn the ignition switch to ON and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the ignition switch off.
  5. Turn the ignition switch to ON and turn the Techstream on [A].
  6. Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or higher [B].
  7. Drive the vehicle for 5 minutes or more [C].
  8. Idle the engine for 30 seconds or more [D].
  9. Enter the following menus: Powertrain/Engine/Utility/All Readiness.
  10. Input the DTC: P0014 or P0015.
  11. Check the DTC judgment result [E].
    TECHSTREAM DISPLAY DESCRIPTION

    Techstream Display Description
    NORMAL
    • DTC judgment completed
    • System normal
    ABNORMAL
    • DTC judgment completed
    • System abnormal
    INCOMPLETE
    • DTC judgment not completed Perform driving pattern after confirming
    • DTC enabling conditions
    UNKNOWN
    • Unable to perform DTC judgment
    • Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit
    CAUTION: When performing the confirmation driving pattern, obey all speed limits and traffic laws.

    HINT:

    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE or UNKNOWN, perform steps [F] through [H].
  12. Drive the vehicle for 5 minutes or more [F].
  13. Idle the engine for 30 seconds or more [G].
  14. Enter the following menus: Powertrain/Engine/Utility/All Readiness.
  15. Input the DTC: P0014 or P0015.
  16. Check the DTC judgment result again [H].
  17. If the test result is UNKNOWN, enter the following menus: Powertrain/Engine/Trouble Codes/Pending.
  18. Read Pending DTCs [H].

    HINT:

    If a pending DTC is output, the system is malfunctioning.

  19. If the test result is INCOMPLETE or UNKNOWN and no pending DTC is output, perform a universal trip and check for permanent DTCs (See DTC CHECK/CLEAR ).

    HINT:

    • If a permanent DTC is output, the system is malfunctioning.
    • If no permanent DTC is output, the system is normal.
scientia non olet · About LEMON Manuals