On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.

CHECK THROTTLE BODY ASSEMBLY
1. Check the throttle control motor operating sounds.
  1. Turn the ignition switch to ON.
  2. When pressing the accelerator pedal, check the operating sound of the running motor. Make sure that no friction noises are emitted from the motor.
    If friction noise exists, replace the throttle body.
2. Check the throttle position sensor.
  1. Connect the Techstream to the DLC3.
  2. Turn the ignition switch to ON.
  3. Turn the Techstream on.
  4. Enter the following menus: Powertrain/Engine/Data List/Throttle Sensor Position.
  5. Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of "Throttle Sensor Position" is within the specification.
    Standard throttle valve opening percentage:
    
    60% or more
    
    NOTE: When checking the standard throttle valve opening percentage, make sure the shift lever is in N.
    
    If the percentage is less than 60%, replace the throttle body assembly.