Heated Oxygen Sensor: Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
- Measure the resistance according to the value (s) in the table below.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION CHART
| Tester Connection |
Condition |
Specified Condition |
| 1 (HT1B) - 2 (+B) |
20°C (68°F) |
11 to 16 Ω |
If the result is not as specified, replace the heated oxygen sensor.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002