LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System (1AR-FE) - Circuit Testing, Component Inspection, Removal & Installation) >> Camshaft Timing Oil Control Valve Assembly >> Removal

Camshaft Timing Oil Control Valve Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side) 
    1. Disconnect the oil control valve connector.
    2. Remove the bolt and oil control valve.
    3. Remove the O-ring from the oil control valve.
      Fig 1: Locating Bolt And Oil Control Valve
      G05997143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side) 
    1. Disconnect the oil control valve connector.
    2. Remove the bolt and oil control valve.
    3. Remove the O-ring from the oil control valve.
      Fig 2: Locating Bolt And Oil Control Valve
      G05997144Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals