On-Vehicle Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
- Connect the Techstream to the DLC3.
- Start the engine and turn the Techstream on.
- Inspect the oil control valve (for intake camshaft).
- Enter the following menus: Powertrain/Engine/Active Test/Control the VVT System (Bank 1).
- Check the engine speed when the oil control valve is operated using the Techstream with the engine coolant temperature at 50°C (122°F) or less.
HINT:
- When performing the active test, the air conditioning should be on.
- Engine coolant temperature when the engine is started should be 30°C (86°F) or less.
Standard Condition
TESTER OPERATION CHARTTester Operation Specified Condition OCV is OFF Normal engine speed OCV is ON Soon after OCV switched from OFF to ON, engine idles roughly or stalls
- Inspect the oil control valve (for exhaust camshaft).
- Enter the following menus: Powertrain/Engine/Active Test/Control the VVT Exhaust Linear (Bank 1).
- Check the engine speed when the oil control valve is operated using the Techstream with the engine coolant temperature at 50°C (122°F) or less.
HINT:
- When performing the active test, the air conditioning should be on.
- Engine coolant temperature when engine is started should be 30°C (86°F) or less.
Standard Condition
TESTER OPERATION CHARTTester Operation Specified Condition 100% Soon after OCV switched from OFF (-100%) to ON (+100%), engine idles roughly or stalls. -100% Normal engine speed