LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System (1AR-FE) - Circuit Testing, Component Inspection, Removal & Installation) >> Accelerator Pedal Rod >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.
  1. CHECK ACCELERATOR PEDAL ASSEMBLY 
    1. Check the voltage.
      1. Connect Techstream to the DLC3.
      2. Turn the ignition switch to ON.
      3. Turn the Techstream main switch on.
      4. Select the menu items: Powertrain/Engine/Data List/Accel Sensor Out No. 1, Accel Sensor Out No. 2.
      5. Operate the accelerator pedal assembly, and then check that the Accelerator Position No. 1 and Accelerator Position No. 2 values are within the specifications.

        Standard Voltage (Accel Sensor Out No. 1) 

        ACCELERATOR PEDAL ASSEMBLY CONDITION CHART

        Accelerator Pedal Assembly Condition Specified Condition
        Released 0.5 to 1.1 V
        Depressed 2.6 to 4.5 V

        Standard Voltage (Accel Sensor Out No. 2) 

        ACCELERATOR PEDAL ASSEMBLY CONDITION CHART

        Accelerator Pedal Assembly Condition Specified Condition
        Released 1.2 to 2.0 V
        Depressed 3.4 to 4.98 V

        If the result is not as specified, check the accelerator pedal assembly, wire harness or ECM.

scientia non olet · About LEMON Manuals