On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.

INSPECT TRANSFER OIL
1. Remove the No. 1 transfer case plug and gasket.
2. Check the oil level is within 0 to 5 mm (0 to 0.20 in.) below the lowest end of the hole for the No. 1 transfer case plug.
  NOTE:
  - When changing oil, recheck the oil level after driving.
  - Excessively large or small quantity of oil may cause some trouble.
  Fig 1: Inspecting Transfer Oil Level
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. When the oil level is too low, check for oil leakage.
4. Tighten the No. 1 transfer case plug with a new gasket.
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
ADD TRANSFER OIL
1. Remove the No. 1 transfer case plug and gasket and supply oil.
  NOTE:
  - When supplying oil, pour it slowly.
  - Supply oil several times at several minutes interval.
  HINT:
  
  The oil level should be within 0 to 5 mm (0 to 0.20 in.) below the lowest end of the hole for the No. 1 transfer case plug.
2. After leaving it alone for 5 minutes, recheck the oil level.
3. Tighten the No. 1 transfer case plug with a new gasket.
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)