LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Transfer Case -MF2A) >> Extension Housing Oil Seal >> Removal

Extension Housing Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE NO. 1 TRANSFER CASE PLUG  (See DISASSEMBLY )
  2. REMOVE TRANSFER DRAIN PLUG  (See DISASSEMBLY )
  3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY  (See REMOVAL )
  4. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL 
    1. Using SST, remove the transfer extension housing type T oil seal from the transfer extension housing sub-assembly.

      SST 09308-00010 

    NOTE: Be careful not to damage the oil-seal-fitted surface and the inside surface of the bush.
    Fig 1: Removing Transfer Extension Housing Type T Oil Seal
    G05417050Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals