VACUUM SWITCHING VALVE (for ACIS): Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
1. Install the vacuum switching valve assembly (for ACIS) with the bolt.
  Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
2. Connect the 2 vacuum hoses, 2 union to connector tube hoses, clamp and connector.
Fig 1: Locating Bolt And Vacuum Switching Valve Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (See INSTALLATION )
INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See INSTALLATION )
INSTALL EJECTOR TUBE (See INSTALLATION )