LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Fuel System (1AR-FE)) >> Fuel Sender Gauge Assembly >> Installation

Fuel Sender Gauge Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Slide the fuel sender gauge to fit the claw.
  2. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE 
    1. Install the fuel suction tube assembly with pump and gauge (See INSTALLATION ).
    Fig 1: Installing Fuel Sender Gauge Assembly With Claw
    G06113128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals