Fuel Sender Gauge Assembly: Inspection

WARNING: This page is about a different variant/trim than selected.

INSPECT FUEL SENDER GAUGE ASSEMBLY

Remove the fuel sender gauge assembly.
Check the operation of the float moving smoothly between F and E.
Measure the resistance between terminals 2 (FE) and 3 (FS) of the connector according to the value(s) in the table below.

RESISTANCE SPECIFICATION

Float Level	Resistance (O)
F	3.0 to 5.0
E	109.0 to 111.0

HINT:

If the value is not as specified, replace the fuel sender gauge assembly.

Fig 1: Measuring Resistance Between Fuel Sender Gauge Assembly Terminals 2 (FE) And 3 (FS) Of Connector