Section 10 (Starting System (1AR-FE)): Starter: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL STARTER ASSEMBLY
1. Install the starter with the 2 bolts.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
  
  Fig 1: Locating Starter Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the starter connector.
3. Install the terminal nut and cover the nut with the cap.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
Fig 2: Locating Starter Connector And Terminal Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 INLET AIR CLEANER (See INSTALLATION )
INSTALL AIR CLEANER BRACKET (See INSTALLATION )
INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 INLET AIR CLEANER (See INSTALLATION )
INSTALL BATTERY (See INSTALLATION )
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).