LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Starting System (1AR-FE)) >> Starter Relay >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT STARTER RELAY (ST) 
    1. Measure the resistance according to the value(s) in the table below.
    Fig 1: Inspecting Starter Relay (ST)
    G04943935Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Standard Resistance 

    STANDARD RESISTANCE

    Tester Connection Condition Specified Condition
    3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
    Battery voltage applied to terminals 1 and 2 Below 1 Ω

    If the result is not as specified, replace the relay.

scientia non olet · About LEMON Manuals