Front Brake Flexible Hose: Installation

NOTE:

Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.
If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Fig 1: Locating Front Flexible Hose
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL FRONT FLEXIBLE HOSE
1. Connect the front flexible hose to the disc brake cylinder assembly with the union bolt and a new gasket.
  Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf)
  
  Fig 2: Locating Front Flexible Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the front flexible hose with a new clip.
  NOTE: Install the clip as far as it will go.
  
  Fig 3: Locating Flexible Hose Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a union nut wrench (10 mm), connect the brake line to the front flexible hose while holding the front flexible hose with a wrench.
  Torque: without union nut wrench
  
  15 N*m (155 kgf*cm, 11 ft.*lbf)
  
  with union nut wrench
  
  14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  Fig 4: Identifying Torque Wrench With Fulcrum Length
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not bend or damage the brake line.
  - Do not allow any foreign matter such as dirt and dust to enter the brake line.
  - Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
  - This torque value is effective when the union nut wrench is parallel to the torque wrench.
4. Install the front flexible hose to the absorber bracket with the bolt.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
  
  Fig 5: Locating Front Flexible Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL BRAKE FLUID RESERVOIR (See ON-VEHICLE INSPECTION )
BLEED BRAKE LINE (See REPLACEMENT )
BLEED BRAKE ACTUATOR (See REPLACEMENT )
INSPECT FOR BRAKE FLUID LEAK
INSPECT FLUID LEVEL (See ON-VEHICLE INSPECTION )
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)