REAR NO. 1 SEAT ASSEMBLY (for LH Side): Removal

REMOVE REAR CENTER SEAT ASSEMBLY
REMOVE REAR SEAT HEADREST ASSEMBLY
1. Press the headrest support button and pull up the headrest to its highest position as shown in the illustration.
  
  Fig 1: Pressing Headrest Support Button
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert a finger or screwdriver into the hole to release the lock. Pull the headrest up as shown in the illustration to remove it.
Fig 2: Pulling Headrest Highest Position
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR SEAT TRACK BRACKET COVER
1. Disengage the 8 claws and remove the 2 rear seat track bracket covers.
  
  Fig 3: Identifying Rear Seat Track Bracket Covers And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR OUTER TRACK BRACKET COVER
1. Disengage the 4 claws and remove the rear outer track bracket cover.
Fig 4: Identifying Rear Outer Track Bracket Cover And Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR INNER TRACK BRACKET COVER
1. Disengage the 4 claws and remove the rear inner track bracket cover.
Fig 5: Removing Rear Inner Track Bracket Cover And Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR SEAT LEG SIDE COVER
1. Disengage the 3 claws.
2. Disengage the clip and remove the rear seat leg side cover.
Fig 6: Removing Rear Seat Leg Side Cover Clip And Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY (w/ Remote Folding Function)
1. Pull down the adjuster's lock piece to release the lock as shown in the illustration.
  
  Fig 7: Pulling Adjuster's Lock Piece
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver wrapped with protective tape, disengage the 2 claws as shown in the illustration.
  
  Fig 8: Disengaging Rear No.1 Seat Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Lift up the seat track adjusting handle to the uppermost position and hold the handle in this position as shown in the illustration.
  
  Fig 9: Lifting Seat Track Adjusting Handle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using a screwdriver wrapped with protective tape, disconnect the rear No. 1 seat lock cable assembly as shown in the illustration.
5. Using a screwdriver wrapped with protective tape, disconnect the rear seat reclining control cable as shown in the illustration.
  
  Fig 10: Disconnecting Rear Seat
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Secure the rear seat reclining control cable with the carpet hole as shown in the illustration.
REMOVE REAR NO. 1 SEAT ASSEMBLY
1. Remove the 3 bolts on the rear side of the seat.
  
  Fig 11: Identifying Rear No. 1 Seat Assembly And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 bolts on the front side of the seat and the rear No. 1 seat assembly.
  NOTE: Be careful not to damage the vehicle body.
  
  Fig 12: Identifying Rear No. 1 Seat Assembly And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002