LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat (Except Hybrid) >> FRONT SEAT CUSHION HEATER (for Power Seat) >> Inspection

FRONT SEAT CUSHION HEATER (for Power Seat): Inspection

  1. INSPECT FRONT SEAT CUSHION HEATER LH 
    1. Check the seat cushion heater.
      1. Apply battery voltage and check the seat cushion heater.

      OK 

      BATTERY TERMINAL REFERENCE

      Measurement Condition Condition Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4      		 Always Seat cushion heater becomes warm

      If the result is not as specified, replace the seat cushion heater.

      NOTE: Immediately after confirming that the seat heater is functioning normally, remove the battery leads. Failing to do so may cause the seat heater to overheat.
      Fig 1: Identifying Front Seat Cushion Heater LH
      G05421997Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check the thermostat.
      1. Apply battery voltage and check the seat cushion heater.

      OK 

      BATTERY TERMINAL REFERENCE

      Measurement Condition Condition Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4      		 Always Seat cushion heater temperature below 54°C (129°F)

      If the result is not as specified, replace the seat cushion heater.

      NOTE: Immediately after confirming that the seat heater is functioning normally, remove the battery leads. Failing to do so may cause the seat heater to overheat.
scientia non olet · About LEMON Manuals