LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Except Hybrid) >> Power Back Door Touch Sensor >> Removal

Power Back Door Touch Sensor: Removal

  1. REMOVE BACK WINDOW UPPER TRIM PANEL ASSEMBLY  (See DISASSEMBLY )
  2. REMOVE BACK DOOR SERVICE HOLE COVER LH  (See ADJUSTMENT )
  3. DISCONNECT POWER BACK DOOR ROD  (See ADJUSTMENT )
  4. REMOVE BACK DOOR TRIM COVER LH  (See ADJUSTMENT )
  5. REMOVE BACK DOOR TRIM COVER RH  (See ADJUSTMENT )
  6. REMOVE BACK DOOR LOCK COVER  (See ADJUSTMENT )
  7. REMOVE ASSIST STRAP HOLE COVER  (See ADJUSTMENT )
  8. REMOVE ASSIST STRAP ASSEMBLY  (See ADJUSTMENT )
  9. REMOVE BACK DOOR TRIM PANEL ASSEMBLY  (See ADJUSTMENT )
  10. REMOVE POWER BACK DOOR SENSOR ASSEMBLY 
    1. Disconnect the connector.
    2. Remove the 4 bolts.
    3. Disengage the 2 clips and remove the power back door sensor assembly.
    Fig 1: Locating Power Back Door Sensor Assembly Bolts And Connector With Clips
    G05422333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals