LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Except Hybrid) >> Power Back Door Touch Sensor >> Inspection

Power Back Door Touch Sensor: Inspection

  1. INSPECT POWER BACK DOOR TOUCH SENSOR 
    1. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    RESISTANCE SPECIFICATION

    Tester Connection Condition Specified Condition
    1-2 Not pressed Approx. 1 kΩ
    1-2 Pressed Below 100 Ω

    If the result is not as specified, replace the sensor.

    Fig 1: Identifying Power Back Door Touch Sensor Connector Terminals
    G05422048Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals