Inspection Procedure
- CHECK BACK DOOR LOCK FUNCTION
- Check if there are any foreign objects interfering with the back door operation.
OK:
There are no foreign objects.
NG: REMOVE FOREIGN OBJECT
OK: Go to next step
- Check if there are any foreign objects interfering with the back door operation.
- CHECK BACK DOOR
- Check the back door operation.
- Turn the door control main switch off.
- Open/close the back door by hand.
OK:
The back door fully opens and closes smoothly.
NG: ADJUST BACK DOOR
OK: Go to next step
- Check the back door operation.
- READ VALUE ON TECHSTREAM (POWER BACK DOOR TOUCH SENSOR)
- Check the Data List to determine if the power back door touch sensor functions properly.
Back door (Power back door ECU)
DATA LIST REFERENCETester Display Measurement Item/Range Normal Condition Diagnostic Note PBD Touch Sen L Power back door touch sensor LH signal/ON or OFF ON: Power back door touch sensor LH pressed
OFF: Power back door touch sensor LH not pressed- PBD Touch Sen R Power back door touch sensor RH signal/ON or OFF ON: Power back door touch sensor RH pressed
OFF: Power back door touch sensor RH not pressed- OK:
The power back door sensors function as specified in the normal condition.
NG: GO TO OTHER FLOW CHART (See TOUCH SENSOR CIRCUIT )
OK: REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (See REMOVAL )