Customize Parameters
HINT:
The following items can be customized.
NOTE:
- After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
- Be sure to record the current settings before customization.
- When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to "OFF", then perform troubleshooting).
- CUSTOMIZE
- Connect Techstream to the DLC3.
- Turn the ignition switch on (IG).
- Turn the tester on.
- Enter the following menus: Select: Customize Setting/
- Select the setting by referring to the table below.
Power back door system
POWER BACK DOOR SYSTEM REFERENCEDisplay (Item) Default Function Setting PBD SW Operation 0.8 s Function that turns power back door closer switch ON when switch is pushed once or held down for 0.8 sec. 0.8s/ON PBD Buzzer ON This function makes the power back door buzzer sound when power back door is operating ON/OFF Wirels PBD SW Operation 0.8 s Function that operates power back door when transmitter switch is pressed in specified way ON/2 times/0.8 s/OFF